Bosch Aerotwin advantages
manufacturer's information
Select wipers by car model
- The best cleaning quality is achieved due to the exact correspondence of the wiper to the shape of the curve of the windshield or rear window of the car, which was achieved by using the Evodium elastic steel plate in the design of the wiper.
- The cleaning tape uses the proven Twin technology of two-component synthetic rubber.
- Pressure is evenly distributed along the entire length of the wiper for maximum contact with the glass surface. This ensures the best visibility and safety in bad weather conditions.
- The aerodynamic profile of the wiper ensures maximum cleaning efficiency even at high speeds.
- Longer service life due to even pressure distribution, which minimizes the effects of damage and wear.
- High resistance to dust and insect contamination due to uniform pressure distribution.
- Reliability of two-component technology:
- perfect operation of the wiper in all weather conditions thanks to the soft, ultra-flexible rubber back;
- long life thanks to the hard wiper blade;
- consistent high quality without contamination (pollen, dust, etc.) due to the use of pure synthetic rubber;
- excellent streak-free cleaning of even the smallest droplets thanks to the properties of the hard working rubber bottom with double micro-edging (performed with an accuracy of 1/100 mm);
- High level of rubber resistance to environmental influences: radiation, ozone, acid rain.
Recommendations for installing brushes Aerotwin (Retrofit)
- The Aerotwin hook-mount wiper blade must be mounted on a blade holder with a blade width of 9 mm. All Aerotwin wipers are equipped with a universal Quick-clip adapter, designed for a leader with a width of 9 mm. If the width of the blade is more than 9 mm, the brush cannot be installed, if it is less than 9 mm, it will not work effectively. For example, this is the situation with russian-made cars LADA (VAZ).
- The Aerotwin wiper blade must be mounted on a level surface of the windshield. In the event that the windshield has a large bulge, the wiper blade on the passenger side will be in the lower right corner (the location of the inspection ticket), not completely adjacent to the glass. A similar situation with the installation of wipers on cars such as Chevrolet Aveo, Daewoo Lanos, Sens. In this case, it is not recommended to select wiper blades smaller than the original ones, as this will not bring significant improvements.
- Pay special attention to the wiper holder. If it presses the wiper lightly (a time factor - this is especially important when installing wipers on older cars), the wiper blade will not work effectively.
- You should also pay special attention to the electric motor. If the electric motor has a low power, the cleaning quality may be unsatisfactory.
If you follow all the above rules, you will be pleasantly surprised by the quality of glass cleaning with Bosch Aerotwin (Retrofit) wiper blades.
Select wipers by car model